Gateway 9415 User Manual page 104

6
Disconnect the USB connector from the control panel module, then slide the module
forward and remove it from the chassis.
Caution
Important
7
Disconnect the front panel cable from the control panel module.
To install the control panel module:
Important
1
Connect the front panel cable to the new control panel module.
2
Guide the front panel cable into the control panel opening in the chassis, then slide
the new control panel module into the chassis far enough to let you connect the USB
cable.
The USB header has a latch to hold the connector on. Be careful to
unlatch the USB connector when removing it from the control panel
or you could damage the connector or the header.
The position of the USB connector is different in the standard control
panel than in the optional local control panel. Note the positions of
the cable connectors as you remove them from the module.
Replacing the standard control panel module with the optional LCP
control panel module requires the removal of the right hot-swap hard
drive.
Optional LCP
control panel
module
www.gateway.com 99