Gateway 9415 User Manual page 82

To replace a fan in the fan module:
1
Follow the instructions in
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
2
Follow the instructions in
3
Follow the instructions in
4
Trace the cable from the failed fan to the connector on the fan distribution board,
then disconnect the cable.
5
Lift the fan from the fan module in the chassis.
6
Insert the replacement fan into the fan module.
Important
7
Connect the fan cable to the connector on the fan distribution board.
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Removing the processor air duct" on page
Make sure that the arrows on top of the fans indicating airflow point
to the back of the chassis. The fan cable should exit the fan mudule
toward the back of the chassis.
www.gateway.com
41. Make
42.
45.
77