Removing A Cd Or Dvd Drive - Gateway 9415 User Manual

11
If you are replacing the drive, follow the instructions in
converted hard drive bay" on page
- OR -
Install an empty hard drive carrier into the empty hard drive bay.
12
Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
13
Follow the instructions in
14
Reconnect all power cords and peripheral device cables, then turn on the server.

Removing a CD or DVD drive

To remove a CD or DVD drive:
1
Follow the instructions in
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
Caution
2
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
3
Follow the instructions in
4
Disconnect the 44-pin CD drive cable from the system board. See
page 6 for the location of the connectors on the system board.
56
52.
"Closing the server case" on page
"Preventing static electricity discharge" on page
The CD or DVD drive is not hot-swappable. Before installing or
removing the drive, make sure that power is turned off and the power
cord is unplugged.
"Opening the server case" on page
www.gateway.com
"Installing a diskette in a
44.
41. Make
42.
"System board" on