Table of Contents
Advertisement
BIOS
The settings in the BIOS Setup utility are not retained
■
Replace the CMOS battery. For instructions, see
page
95.
CD drive
Your server does not recognize a CD or the CD drive
■
Restart your server, then open the BIOS Setup utility by pressing and holding F2 while
your server restarts. Make sure that the IDE controllers are enabled. For more
information, see
■
Reinstall the device driver. For instructions, see Using Your System Companion CD.
■
Make sure that the drive is configured correctly by following the instructions in the
drive's documentation.
■
Turn off your server, then remove the drive and push it in again to make sure the
drive is seated correctly. For instructions, see
page
58.
Your CD drive tray does not open
■
Press a straightened paper clip wire into the CD drive's manual eject hole. The drive
tray opens.
■
If this problem happens frequently while the server is turned on, the drive may be
defective.
Expansion cards
Your server does not recognize an expansion card
■
Restart your server.
■
Make sure that you have installed the necessary software or driver. For instructions,
see the card's documentation.
■
Reseat the expansion card and riser card. For instructions, see
PCI expansion cards" on page
■
If another slot of the correct size is available, install the card in a different slot.
"Using the BIOS Setup Utility" on page
69.
www.gateway.com
"Replacing the CMOS battery" on
107.
"Installing a CD or DVD drive" on
"Installing and removing
135
Advertisement
Table of Contents
Troubleshooting
