Main Motor - Tektronix PHASER 560 Service Manual

8
FRU Disassembly/Assembly

Main motor

Paper feed motor
Toner cartridge drive motor
8-18 Phaser 560 Color Printer
Downloaded from www.Manualslib.com
The main motor can be differentiated from the toner cartridge drive motor and
the paper feed motor by its lack of heat sinks.
1. Remove the upper and lower rear covers and the left side cover as
explained in the earlier procedure, "The printer cabinet" on page 8-2.
Remove the EMI shields as detailed in the earlier procedure "EMI
shields" on page 8-6.
2. Remove the engine control board and bracket as explained in the
previous procedure, "Engine control board" on page 8-17.
3.
Disconnect the motor's wiring harness.
4.
Remove the four screws holding the main motor in place. Remove the
motor.
1. Remove the upper and lower rear covers and the left side cover as
explained in the earlier procedure, "The printer cabinet" on page 8-2.
Remove the EMI shields as detailed in the earlier procedure "EMI
shields" on page 8-6.
2. Remove the engine control board and bracket as explained in the
previous procedure, "Engine control board" on page 8-17.
3.
Remove the four screws holding the paper feed motor in place.
Remove the motor.
1.
Remove the upper and lower rear covers and the left side cover as
explained in the earlier procedure, "The printer cabinet" on page 8-2.
Remove the EMI shields as detailed in the earlier procedure "EMI
shields" on page 8-6.
2. Remove the engine control board and bracket as explained in the
previous procedure, "Engine control board" on page 8-17.
3. Remove the four screws holding the toner cartridge drive motor in
place. Remove the motor.
manuals search engine