Inserting The Rtm Lan Card To Its Slot - Polycom Collaboration Server (RMX) 2000 Hardware Manual

RealPresence Collaboration Server (RMX) 2000 Hardware Guide
4
5

Inserting the RTM LAN Card to its Slot

1
2
An RTM LAN card must connect directly to an MPM/MPM+/MPMx card in the opposite facing front
slot.
3
4
5
6
7
1-38
Use the metal ejector levers to pull the RTM LAN card out of its slot in the backplane.
Carefully slide the RTM LAN card out through the rear panel.
On the card to be installed, move the ejector levers to their fully open position.
Slide in the replacement RTM LAN card.
Push the RTM LAN card firmly into the backplane, making sure it is properly seated in
its slots.
Ensure that the metal ejector levers are fully retracted into their housings.
Tighten the captive screws on the rear panel of the RMX 2000 that secure the RTM LAN
card.
Reconnect the cables.
Turn ON the RMX 2000.
Polycom, Inc.