Table of Contents
Advertisement
RealPresence Collaboration Server (RMX) 2000
Components
On the RMX 2000 components are located on both the front and rear of the MCU as listed in
Table 1-6, "RMX 2000 Component Description". For more information see the descriptions of
the "RealPresence Collaboration Server (RMX) 2000 Front Panel" on page
Collaboration Server (RMX) 2000 Rear Panel" on page 1-15.
Please verify the type of chassis used on your RMX 2000. Starting with version 4.0, a new
environmentally friendly RMX 2000 chassis is in use. For more information, contact your next level
of support.
RealPresence Collaboration Server (RMX) 2000 Front Panel
Figure 1-6 shows the front panel of the RMX 2000. The front panel provides access to the
RMX 2000 main CNTL modules, MPM/MPM+/MPMx modules, Power Supply drawer,
Status LEDs, and Fans.
Figure 1-6
Table 1-6
Component
CNTL (CPU) Module
Power Supply Drawer
Fan Drawer
Polycom, Inc.
MPM/MPM+/MPMx Cards & LEDs
ERR
RDY
ACT
ERR
RDY
ACT
RMX 2000
Power supply Drawer
RMX 2000 Front Panel
RMX 2000 Component Description
Description
The CNTL module controls and manages the RMX 2000. The CNTL
module has an ComExpress Pentium-M 1.4GHz processor, a 40GB
hard disk drive, 1GB Compact Flash and 1GB of DDR RAM.
The Operating System is Linux.
The Power Supply drawer is located below the MPM/MPM+/MPMx
Cards and is connected to the backplane by means of a power
connector. It operates at 100-240 volts AC 50/60 Hz, and provides
+48VDC 700W output with built-in load sharing capabilities.
Three fans are mounted sideways in a drawer. Airflow is from right to
left, and out the side of the MCU. The drawer is connected to the
Back-plane by a connector.
Chapter 1-Hardware Description
HS
MPM+80
HS
MPM+80
CNTL
ERR RDYACT HD HS
PWR
CNTL
USB ports - not for
Control Unit
customer use
& LEDs
1-13
and "RealPresence
Fan Drawer
Fan &
Power
FAN
STATUS
Status
PWR
STATUS
LEDs
FANS
Optional CPU &
LEDs
1-13
Advertisement
Table of Contents
