Table of Contents
Advertisement
The following table summarizes the resource capacities for a fully loaded system per card
type per line rate in VSW conferencing mode:
Table 1-4
Resource Type and Line Rate
VSW 2Mb
VSW 4Mb
VSW 6Mb
ISDN
Safety Requirements
This section describes the requirements your site must meet for safe installation and
operation of the system.
Site Safety Requirements
For your protection, please read these safety instructions completely before operating the
equipment.
•
•
•
•
•
•
•
•
•
•
Rack Mount Safety Precautions
The following precautions should be followed with regards to rack mount safety:
•
•
Polycom, Inc.
System Resource Capacities per Line Rate per Card Type in VSW
Look carefully for potential hazards in your work area: moist floors, ungrounded
power cables, frayed power cords, missing safety grounds and so forth.
Locate the main circuit breaker within the room.
Locate the emergency power OFF switch within the room.
Never assume that power is disconnected from a circuit.
Use only the power cord supplied with the system.
The power cord should only be connected to a power outlet that has a protective
ground contact.
Ensure that the power cord is easily accessible from the back of the system at all times.
Place the equipment in a well-ventilated area where the vents are free from obstruction.
Do not place heavy objects directly on top of the RMX 2000 unit.
Do not use liquids around your equipment.
Keep the area around the RMX 2000 clean and free of clutter.
Decide on a suitable location for the equipment rack that will hold the RMX 2000 unit. It
should be situated in a clean, dust-free area that is well ventilated. Avoid areas where
heat, electrical noise and electromagnetic fields are generated. You will also need it
placed near a grounded power outlet.
Resources with
Resources with
MPM
MPM+
80
160
40
80
N/A
40
7 E1 or 9 T1
(per RTM ISDN card)
Chapter 1-Hardware Description
Resources with
MPMx
160
80
40
1-5
Advertisement
Table of Contents
