Removing The Blank Cover From The Rear Panel - Polycom Collaboration Server (RMX) 2000 Hardware Manual

3
4
5
6
7
8
9
10 Turn ON the RMX 2000.
For more information on the Card Configuration Modes after reset, see "MPMx, MPM+ and MPM
Modes" on page 1-21.

Removing the Blank Cover from the Rear Panel

Use the following procedure to remove the blank cover:
1
2
3
Polycom, Inc.
Use the metal ejector levers to pull the RTM IP card out of its slot in the backplane.
Carefully slide the RTM IP card out through the rear panel.
On the card to be installed, move the ejector levers to their fully open position.
Slide in the replacement RTM IP card.
Push the RTM IP card firmly into the backplane, making sure it is properly seated in its
slots.
Ensure that the metal ejector levers are fully retracted into their housings.
Tighten the captive screws on the rear panel of the RMX 2000 that secure the RTM IP
card.
Ensure that the power switch/circuit switch on the RMX is turned OFF (O).
Unscrew the captive screws on the rear panel of the RMX that secure the blank panel.
Use the metal ejector levers to pull the blank panel.
Chapter 1-Hardware Description
1-35