Table of Contents
Advertisement
4
5
6
7
8
9
10 Turn ON the RMX 2000.
For more information on the Card Configuration Modes after reset, see "MPMx, MPM+ and MPM
Modes" on page 1-21.
Replacing the Power Supply Module
A single supply unit powers the RMX 2000. Use the following procedure to replace a Power
Supply:
Please verify the type of power supply used on your RMX 2000. Do not insert a different type of
power supply than the current type installed on your system.
1
2
3
4
Polycom, Inc.
Carefully slide the
CNTL
On the
CNTL
Module to be installed, move the ejector lever to the fully open position.
Slide in the replacement
Push the
CNTL
Module firmly into the Backplane, making sure it is properly seated in
its slot.
Ensure that the metal ejector lever is fully retracted into its housing.
Tighten the captive screws on the front panel of the RMX 2000 that secure the
CNTL
Functional
Module.
Ensure that the power switch on the RMX 2000 is turned OFF (O) and that the power
cords are disconnected from the MCU.
Unscrew the captive screws on the front panel of the RMX 2000 that secure the Power
Supply unit.
Use the finger grip to pull the Power Supply unit out of its slot in the Backplane.
Carefully slide the Power Supply unit out through the front panel.
Module out through the front panel.
CNTL
Module.
Chapter 1-Hardware Description
1-31
Advertisement
Table of Contents
