Realpresence Collaboration Server (Rmx) 2000 Rear Panel; Rtm Ip - Polycom Collaboration Server (RMX) 2000 Hardware Manual

RealPresence Collaboration Server (RMX) 2000 Rear Panel

The RMX 2000 rear panel contains the RTM IP card and optionally, the RTM LAN and RTM
ISDN card. The RTM IP card must be located on the bottom slot in the rear of the RMX 2000.
In addition, the rear panel houses the main power switch, AC inlet, a circuit breaker, and
additional communications ports.

RTM IP

The RTM IP card provides system management based on the ATCA standard and connects
to the backplane. It controls and monitors the system fans and regulates power supply. This
card contains an Ethernet Switch that manages the network of the system, routes data
between the cards and components of the system and provides connectivity to external IP
networks.
The RTM IP card connections include:
•
•
•
•
LAN1*, LAN3 and the 10/100Mb ShMG ports shall not be used and the plastic caps covering those
ports should not be removed.
* With Multiple networks and LAN redundancy configurations, LAN 1 port is used. For more
information, see RealPresence Collaboration Server (RMX) 1500/2000/4000 Administrators Guide
Administrator's Guide, "LAN Redundancy" on page 16-32 and "Multiple Network Services" on page
16-49.
Figure 1-7
The following items appear on the RMX 2000 rear panel:
Table 1-7
Item
LAN 1
LAN 2
Polycom, Inc.
3 LAN ports
10/100Mb ShMG port (Future Use)
1 Serial port (Future Use)
1 USB port
LAN 1-3 Ports
& LEDs
LAN1, LAN 3, ShMG and the Serial ports are only
for debugging and not for customer use
RMX 2000 RTM IP Rear Panel Layout
RMX 2000 Rear Panel - RTM IP Component Description
Description
NA - Disconnected. LAN 1 is covered with a plastic cap that should not be
removed.
Used for the Network connection.
Internal LAN
connection
10/100Mb ShMG
LEDs
LAN & LEDs
Chapter 1-Hardware Description
Serial USB Standby button &
Port LED
Port
1-15