Itp Application Programming Examples - Samsung Officeserv 7100 Technical Manual

OfficeServ 7100
TECHNICAL MANUAL

ITP Application Programming Examples

In the following example shows the private corporate LAN application on the enterprise
network. The network is considered "private" because all of the IP addresses are on
the same network. In the following example the IP addresses are "static" and were
provided by the IT person that manages the IP network.
Router/Hub
IP: 105.52.10.1
Subnet:
255.255.255.0
Programming this application on the OfficeServ 7100 system is as follows:
1. MMC 830 ETHERNET PARAMETERS
Note: If you are using on-board MGI channels MMC 831 is "read only". The
MP10/MP10a's IP will be used for the MGI function also)
• SYSTEM IP ADDR: 105.52.10.100 (MP10/MP10a IP address)
• SYSTEM GATEWAY: 105.52.10.1
• SYSTEM NET MASK: 255.255.255.0
• SYSTEM RESTART: Yes
• SYSTEM IP TYPE: PRIVATE (default)
2. MMC 831 MGI PARAMETERS (If you are using the MGI-16 card)
Note: If you are using on-board MGI channels MMC 831 is "read only". The
MP10/MP10a's IP will be used for the MGI function also)
• IP ADDRESS: 105.52.10.101
• GATEWAY: 105.52.10.1
• SUB MASK: 255.255.255.0
• PUBLIC IP: Not Applicable (default 1.1.1.1)
MP10/MP10A
105.52.10.100
MGI
105.52.10.101
105.52.10.54
105.52.10.150
Extension 3201
105.52.10.151
Extension 3202
2.6.26
Table of Contents
Home Page
SPECIAL APPLICATIONS
PART 2 JANUARY 2009