Installing Cabinets; System Installation Procedure; Selecting Installation Method; Installing In A Rack - Samsung OfficeServ 7200 Technical Manual

OfficeServ 7200
TECHNICAL MANUAL
PART 2. INSTALLING CABINETS
This section describes how to install an OfficeServ 7200 cabinet on a table/desktop in a
data rack or on a wall, depending on the installation environment.

2.1 SYSTEM INSTALLATION PROCEDURE

The procedure of system installation is as follows.
1) Install the OfficeServ 7200 cabinet on a table, inside a data rack or on the wall
depending on the installation environment.
2) Connect the ground to the ground lug behind the main cabinet.
3) Put the MCP board into slot 0 of the main cabinet. If there is an expansion cabinet,
install the LCP board into slot 0 of the expansion cabinet.
4) Install interface boards into universal slots (slot 1 through slot 5) of the Main Cabinet
and if required slots 1 through 5 of expansion cabinet.
5) Connect an external battery with proper capacity if required.
6) Connect AC 110 V input power.

2.2 SELECTING INSTALLATION METHOD

The OfficeServ 7200 cabinet can be installed on a table, inside a 19-inch rack or on a
wall depending on the number of cabinets and environment of the installation area.

2.3 INSTALLING IN A RACK

2.3.1 Cautions for Installation
Take the following precautions when installing the OfficeServ 7200 cabinet inside a
rack:
• The 19-inch rack should be a standard equipment rack.
• When using an enclosed-type rack, check if the rack is properly ventilated. Vents
should be equipped on the side of the rack and fans should be attached to ventilate
cool air into the rack.
• Take special caution when using an enclosed-type rack that has vents on top of the
rack since hot air coming out of the vent may enter the intake vent of a system
installed above the rack.
• When using an open rack, do not block the entrance of a port or fan of the
OfficeServ 7200 system.
Home Page
PART 2 SEPTEMBER 2005
2.1
Table of Contents
INSTALLATION