2. To add a new LWAPP AP group, select Yes in the AP Groups section. Additional controls appear.
3. Select Add to create a new LWAPP AP group. To edit an existing LWAPP AP group, select the pencil icon
next to that group. Add one or more SSIDs and the interface/VLAN ID mapping on the Add/Edit page of the
LWAPP AP Group.
4. Select Save and Apply to make these changes permanent, or select Save to retain these changes to be pushed
to controllers at a later time.
Configuring Cisco Controller Settings
The Groups > Cisco WLC Config > Controller page defines general Cisco WLC settings, Multicast settings,
Cisco mobility groups to be supported on Cisco controllers, Network Transfer Protocol (NTP), and Spanning
Tree Protocol settings.
Go to the Groups > Cisco WLC Config > Controller page. This navigation is illustrated in
Figure 54 Groups > Cisco WLC Config > Controller Navigation
Configuring Wireless Parameters for Cisco Controllers
This section illustrates the configuration of Wireless settings in support of Cisco WLC controllers. The navigation
for Wireless settings is illustrated in
Figure 55 Groups > Cisco WLC Config > Wireless Navigation Illustration
Configuring Cisco WLC Security Parameters and Functions
AMP enables you to configure many security settings that are specific to Cisco WLC controllers. This section
supports four overriding types of configuration, as follows:
AAA, to cover both RADIUS and TACACS+ server configuration
Priority Order
Wireless Protection Policies
Web Auth
Dell PowerConnect W-AirWave | User Guide
Figure
55.
Figure
Configuring and Using Device Groups in AMP | 93
54.