Dell PowerConnect W-Airwave User Manual page 75

5. Record additional information and comments about the group in the Notes section.
6. To configure which options and tabs are visible for the group, complete the settings in the Group Display
Options section.
Table 41 Group Display Options Fields and Default Values
Setting
Show device
settings for:
Selected Device
Types
7. To assign dynamically a range of static IP addresses to new devices as they are added into the group, locate the
Automatic Static IP Assignment section on the Groups > Basic configuration page. If you select Yes in this
section, additional fields appear. Complete these fields as required.
default values This section is only relevant for a small number of device types, and will appear when they are
present.
Table 42 Automatic Static IP Assignment Fields and Default Values
Setting
Assign Static IP
Addresses to
Devices
Start IP Address
Number of
Addresses
Subnet Mask
Subnet Gateway
Next IP Address
Dell PowerConnect W-AirWave | User Guide
Table 41 describes the settings and default values.
Default Description
Only Drop-down menu determines which Group tabs and options are to be viewable by default in
devices on new groups. Settings include the following:
this AMP
All Devices—AMP displays all Group tabs and setting options.

Only devices in this group—AMP hides all options and tabs that do not apply to the devices

in the group. If you use this setting, then to get the group list to display the correct SSIDs
for the group, you must Save and Apply on the group.
Only devices on this AMP— hides all options and tabs that do not apply to the APs and

devices currently on AMP.
Use system defaults—Use the default settings on AMP Setup > General.

Selected device types—Allows you to specify the device types for which AMP displays

Group settings.
N/A This option appears if you chose to display selected device types, allowing you to select the
device types to display group settings. Use Select devices in this group to display only devices
in the group being configured.
Default Description
No Enables AMP to statically assign IP addresses from a specified range to all devices in the
Group.
Blank Sets the first address AMP assigns to the devices in the Group.
Blank Sets the number of addresses in the pool from which AMP can assign IP addresses.
Blank Sets the subnet mask to be assigned to the devices in the Group.
Blank Sets the gateway to be assigned to the devices in the Group.
Blank Defines the next IP address queued for assignment. This field is disabled for the initial Access
Points group.
Table 42 describes the settings and
Configuring and Using Device Groups in AMP | 75