Cisco Wlc Group Configuration; Accessing Cisco Wlc Configuration; Navigating Cisco Wlc Configuration - Dell PowerConnect W-Airwave User Manual

Table 62 Groups > Radio > Proxim 4900M Fields and Default Values (Continued)
Setting
802.11a/4.9GHz Public
Safety Operational Mode
7. To configure Symbol-only settings, locate the Symbol section and define the required fields.
describes the settings and default values.
Table 63 Groups > Radio > Symbol Fields and Default Values
Setting
Rogue Scanning
Rogue Scanning
Interval (5-480 min)
8. Select Save when radio configurations as described above are complete, select Save and Apply to make the
changes permanent, or select Revert to discard all unapplied changes.

Cisco WLC Group Configuration

The Groups > Cisco WLC Config page consolidates the settings for Cisco WLC devices from all group pages.
The Groups > SSIDs subtab applies to all device types except for Cisco WLC, which have WLANs configured
on the Cisco WLC Config page. It is not recommended to have Symbol 4131 and Proxim APs in the same group
as Cisco devices. Also, it is recommended that users set device preferences to Only devices in this group. This
topic describes how to access and navigate the Groups > Cisco WLC Config page.

Accessing Cisco WLC Configuration

Go to the Cisco WLC Config page in one of these two ways:
1. In Groups > List, select a group that has been defined to support Cisco devices and the Cisco WLC Config
option appears in the subtabs.
2. In Groups > List, create a new group to support Cisco devices with these steps:
Select Add from the Groups > List page to create a new group, enter a group name, and select Add.

Once AMP prompts you with the Groups > Basic page, ensure that you enable device-specific settings for

Cisco WLC.
Once you select Save or Save and Apply, then the Groups > Cisco WLC Config subtab appears in the

navigation pane at the top in association with that group.

Navigating Cisco WLC Configuration

The navigation pane on the left side of the Groups > Cisco WLC Config page is expandable, and displays the
Cisco configurations supported and deployed.
You can pre-populate the group WLC settings from a controller in the same group by performing an import on
the controller's Audit page.
Dell PowerConnect W-AirWave | User Guide
Default Description
802.11a This setting specifies if the AP will run the 802.11a/4.9GHz radio in 802.11a mode or in
4.9 GHz mode. Please note that 4.9 GHz is a licensed frequency used for public safety.
Default Description
Yes If enabled, Symbol access points with 3.9.2 or later firmware in the group will passively scan
for rogue access points at the specified interval. This rogue scan will not break a user's
association to the network.
240 If rogue scanning is enabled, this setting controls the frequency with which scans are
conducted (in minutes). Frequent scans provide the greatest security, but AP performance
and throughput available to user devices may be impacted modestly during a rogue scan.
Figure 46 and Figure 47 illustrate this navigation pane.
Configuring and Using Device Groups in AMP | 89
Table 63