Checking Signal Strength to Client Location
1. On a Floor Plan, locate the Signal Cutoff menu.
2. Select the desired signal level to display, as shown in
Figure 221 Signal Cutoff dBm Dropdown Menu
Viewing an AP's Wireless RF Environment
To view an access point's RF environment from APs/Devices > Monitor page:
1. Select a device of interest from APs/Devices > List, or any other AMP page that lists your APs. The APs/
Devices > Monitor page opens.
2. Click on the QuickView thumbnail showing the location of the AP, shown on the right side of
Figure 222 QuickView Thumbnail in APs/Devices > Monitor page for an AP
A fully interactive QuickView display opens below the thumbnail on the same page (not in a new window), as
shown in
Figure 223 Full QuickView in APs/Devices > Monitor page for an AP (partial view)
278 | Using VisualRF
Figure
223:
Figure
221. The heatmap updates immediately.
Dell PowerConnect W-AirWave | Version 7.3
Figure
222: