Dell PowerConnect W-Airwave User Manual page 84

Figure 44 Groups > SSIDs > Add SSID/VLAN Page Illustration
4. Locate the SSID/VLAN section on the Groups > SSIDs configuration page and adjust these settings as
required. This section encompasses the basic VLAN configuration.
values. Note that the displayed settings can vary.
Table 55 Groups > SSIDs > SSID/VLAN Section Fields and Default Values
Setting
Specify Interface Name
Interface
SSID
Name
VLAN ID (1-4094)
Maximum Allowed
Associations (0-2007)
Broadcast SSID (Cisco
WLC, Proxim and Symbol
4131 only)
Partial Closed System
(Proxim only)
Unique Beacon
(Proxim only)
Block All Inter-Client
Communication
84 | Configuring and Using Device Groups in AMP
Default Description
Yes Enables or disables an interface name for the VLAN interface. Selecting No for this
option displays the Enable VLAN Tagging and VLAN ID options.
None Sets the interface to support the SSID/VLAN combination.
None Sets the Service Set Identifier (SSID), which is a 32-character user-defined identifier
attached to the header of packets sent over a WLAN. It acts as a password when a
mobile device tries to connect to the network through the AP, and a device is not
permitted to join the network unless it can provide the unique SSID.
None Sets a user-definable name associated with SSID/VLAN combination.
None Indicates the number of the VLAN designated as the Native VLAN, typically for
management purposes
255 Indicates the maximum number of mobile users which can associate with the
specified VLAN/SSID.
NOTE: 0 means unlimited for Cisco.
No For specific devices as cited, this setting enables the AP to broadcast the SSID for
the specified VLAN/SSID. This setting works in conjunction with the Create Closed
Network setting on the Groups > Security configuration page. Proxim devices support
a maximum of four SSIDs.
NOTE: This option should be enabled to ensure support of legacy users.
No For Proxim only, this setting enables to AP to send its SSID in every beacon, but it
does not respond to any probe requests.
No For Proxim only, if more than one SSID is enabled, this option enables them to be sent
in separate beacons.
Yes This setting blocks communication between client devices based on SSID.
Table 55 describes the settings and default
Dell PowerConnect W-AirWave | Version 7.3