Dell PowerConnect W-Airwave User Manual page 77

11. To configure settings specific to Cisco WLC, locate the Cisco WLC section and adjust these settings as
required.
Table 46 Cisco WLC Fields and Default Values
Setting
SNMP Version
CLI Communication
NOTE: When configuring Cisco WLC controllers, refer to
12. To configure Proxim/Avaya specific settings locate the Proxim/Avaya section and adjust these settings as
required.
Table 47 Proxim/Avaya Fields and Default Values
Setting
SNMP Version
Enable DNS
Client
Primary DNS
server
Secondary DNS
server
Default DNS
domains
HTTP Server Port 80
Country Code
13. To configure HP ProCurve specific settings, locate the HP ProCurve section and adjust these settings as
required.
Table 48 HP ProCurve Fields and Default Values
Setting
SNMP Version
ProCurve XL/ZWeSM CLI
Communication
Controller SNMP Version 2c
NOTE: DST Start Month, Start Day, End Month, End Day, and DST Offset are only visible if Daylight Saving Time is enabled in the
NTP section of the Groups > Basic configuration page.
Dell PowerConnect W-AirWave | User Guide
Table 46 describes the settings and default values.
Default Description
2c Sets the version of SNMP used by AMP to communicate to WLC controllers.
Telnet Sets the protocol AMP uses to communicate with Cisco IOS devices. Selecting SSH
uses the secure shell for command line page (CLI) communication. Selecting Telnet
sends the data in clear text via Telnet.
Table 47 describes the settings and default values.
Default Description
1 Sets the version of SNMP used by AMP to communicate to the AP.
No Enables the DNS client on the AP. Enabling the DNS client allows you to set some values on the
AP by hostname instead of IP address. If you select Yes for this setting, additional DNS fields
display.
Blank Sets the IP address of the Primary DNS server.
Blank Sets the IP address of the Secondary DNS server.
Blank Sets the default DNS domain used by the AP.
Sets this port as the HTTP server port on all Proxim APs in the group.
United Configures AMP to derive its time settings based on the country of location, as specified in this
States field.
Table 48 describes the settings and default values.
Default Description
2c Sets the version of SNMP used by AMP to communicate to the AP.
Telnet Sets the protocol AMP uses to communicate with ProCurve XLWeSM devices. Selecting
SSH will use the secure shell for command line (CLI) communication. Selecting Telnet
will send the data in clear text via telnet.
Specifies the version of SNMP used by AMP to communicate to the controller.
"Configuring Wireless Parameters for Cisco Controllers" on
Configuring and Using Device Groups in AMP | 77
page 93.