Figure 4
4. Select Save.
Setting Up Time Synchronization
Setting up NTP on AirWave
On the AMP Setup > Network page, locate the Network Time Protocol (NTP) section. The Network Time
Protocol is used to synchronize the time between AirWave and your network reference NTP server. NTP servers
synchronize with external reference time sources, such as satellites, radios, or modems.
NOTE: Specifying NTP servers is optional. NTP servers synchronize the time on the AirWave server, not on individual access
points.
To disable NTP services, clear both the Primary and Secondary NTP server fields. Any problem related to
communication between AirWave and the NTP servers creates an entry in the event log. For more information
on ensuring that AirWave servers have the correct time, please see
NTPPoolServers.
Table 2
Setting
Primary
Secondary
You can set the clock on a controller manually or by configuring the controller to use a Network Time Protocol
(NTP) server to synchronize its system clock with a central time source.
Manually Setting the Clock on a Controller
You can use either the WebUI or CLI to manually set the time on the controller's clock.
1. Navigate to the Configuration > Management > Clock page.
2. Under Controller Date/Time, set the date and time for the clock.
3. Under Time Zone, enter the name of the time zone and the offset from Greenwich Mean Time (GMT).
4. To adjust the clock for daylight savings time, click Enabled under Summer Time. Additional fields appear
that allow you to set the offset from UTC, and the start and end recurrences.
5. Click Apply.
Enabling Support for Channel Utilization And Statistics
In order to enable support for channel utilization statistics, you must have the following:
AirWave 7.2 or later
Dell PowerConnect W-AirWave 7.5 | Best Practices Guide
Timeout settings in Device Setup > Communication
AMP Setup >Network > Secondary Network Fields and Default Values
Default
ntp1.yourdomain.com
ntp2.yourdomain.com
Description
Sets the IP address or DNS name for the primary NTP server.
Sets the IP address or DNS name for the secondary NTP server.
Configuring AirWave for Global Dell PowerConnect W-Series Infrastructure | 7
http://support.ntp.org/bin/view/Servers/