Enabling Amp To Manage Your Devices; Configuring Communication Settings For Discovered Devices - Dell PowerConnect W-Airwave User Manual

Enabling AMP to Manage Your Devices

Once AMP is installed and active on the network, the next task is to define the basic settings that allow AMP to
communicate with and manage your devices. Device-specific firmware files are often required or are highly
desirable. Furthermore, the use of Web Auth bundles is advantageous for deployment of Cisco WLC wireless
LAN controllers when they are present on the network.
This section contains the following procedures:

Configuring Communication Settings for Discovered Devices


Loading Device Firmware Onto AMP (optional)

Overview of the Device Setup > Upload Firmware & Files Page

Loading Firmware Files to AMP

Configuring Communication Settings for Discovered Devices
To configure AMP to communicate with your devices, to define the default shared secrets, and to set SNMP
polling information, navigate to the Device Setup > Communication page, illustrated in
Figure 27 Device Setup > Communication Page Illustration
Perform the following steps to define the default credentials and SNMP settings for the wireless network.
1. On the Device Setup > Communication page, locate the Default Credentials area. Enter the credentials for
each device model on your network. The default credentials are assigned to all newly discovered APs.
52 | Configuring AMP
Figure 27.
Dell PowerConnect W-AirWave | Version 7.3