Dell PowerConnect W-Airwave User Manual page 251

Select Cancel to exit from the Add page.

Table 135
to view additional information on that report type.
Table 135 Report Types and Scheduling Options Supported for Custom Reports
Report Type
Using Custom Reports
Using the Capacity
Planning Report
Using the
Configuration Audit
Report
Using the Device
Summary Report
Using the Device
Uptime Report
Using the IDS Events
Report
Using the Inventory
Report
Using the Memory and
CPU Utilization Report
Using the Network
Usage Report
Using the New Rogue
Devices Report
Using the New Users
Report
Using the PCI
Compliance Report
Using the Port Usage
Report
Using the RADIUS
Authentication Issues
Report
Using the RF Health
Report
Using the RF Health
Report
Using the User Session
Report
Dell PowerConnect W-AirWave | User Guide
describes the configurable settings for the custom report to be created. Select any of the report names
Can by Run by
Time Period
Yes
Yes
No
Yes
Yes
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
Can be Run by
Description
Group/Folder
Yes Summarizes devices based on which have exceeded a
defined percentage of their maximum bandwidth capacity.
Pulls data for AP radios or interfaces of universal devices
(ifSpeed value).
Yes Tracks bandwidth capacity and consumption according to
thresholds for data throughput. This is a device-oriented
report.
Yes Provides a snapshot of the configuration of all specified
access points in AMP, at report run time.
Yes Summarizes user and bandwidth statistics and lists devices in
AMP.
Yes Summarizes device uptime within defined groups or folders.
Yes Summarizes IDS events; can be limited to a summary of a
certain number of events.
Yes Provides an audit of vendors, models and firmware versions
of devices in AMP.
Yes Summarizes usage for controllers for defined top number of
devices; can be run with or without per-CPU details and
details about device memory usage.
Yes Summarizes bandwidth data and number of users.
No Shows new rogue devices by score, discovering AP, and MAC
address vendor.
No Provides a summary list of new users, including username,
role, MAC address, discovering AP, and association time.
Yes Provides a summary of network compliance with PCI
requirements, according to the PCI requirements enabled in
AMP using the AMP Setup > PCI Compliance page.
Yes Summarizes switch and port information across the network.
Generates information on the unused ports. Provides a
detailed list of all available switches and ports in the network.
Yes Summarizes RADIUS authentication issues by controller and
by user, as well as a list of all issues.
Yes Tracks problematic radios, changes, errors, and interfering
devices.
Yes Identifies discrepancies between access point containment
status specified in AMP compared to containment status
identified by the controller at report run time.
Yes Summarizes user data by radio mode, SSID and VLAN, as well
as lists all sessions.
Creating, Running, and Emailing Reports | 251