Dell PowerConnect W-Airwave User Manual page 76

8. To configure Spanning Tree Protocol on WLC devices and Proxim APs, locate the Spanning Tree Protocol
section on the Groups > Basic configuration page. Adjust these settings as required.
settings and default values.
Table 43 Spanning Tree Protocol Fields and Default Values
Setting
Spanning Tree
Protocol
Bridge Priority
Bridge Maximum
Age
Bridge Hello Time 2
Bridge Forward
Delay
9. To configure NTP settings locate the NTP section and adjust these settings as required.
the settings and default values.
Table 44 NTP Fields and Default Values
Setting
NTP Server #1,2,3 None
UTC Time Zone
Daylight Saving
Time
10. To configure settings specific to Cisco IOS/Catalyst, locate the Cisco IOS/Catalyst section and adjust these
settings as required.
Table 45 Cisco IOS/Catalyst Fields and Default Values
Setting
SNMP Version
Cisco IOS CLI
Communication
Cisco IOS Config File
Communication
76 | Configuring and Using Device Groups in AMP
Default Description
No Enables or disables Spanning Tree Protocol on Proxim APs.
32768 Sets the priority for the AP. Values range from 0 to 65535. Lower values have higher priority.
The lowest value is the root of the spanning tree. If all devices are at default the device with
the lowest MAC address will become the root.
20 Sets the maximum time, in seconds, that the device stores protocol information. The
supported range is from 6 to 40.
Sets the time, in seconds, between Hello message broadcasts.
15 Sets the time, in seconds, that the port spends in listening and learning mode if the spanning
tree has changed.
Default Description
Sets the IP address of the NTP server to be configured on the AP.
0 Sets the hour offset from UTC time to local time for the AP. Times displayed in AMP graphs and
logs use the time set on the AMP server.
No Enables or disables the advanced daylight saving time settings in the Proxim section of the
Groups > Basic configuration page.
Table 45 describes the settings and default values.
Default Description
2c The version of SNMP used by AMP to communicate to the AP.
Telnet The protocol AMP uses to communicate with Cisco IOS devices. Selecting SSH uses
the secure shell for command line page (CLI) communication. Selecting Telnet sends
the data in clear text via Telnet.
TFTP The protocol AMP uses to communicate with Cisco IOS devices. Selecting SCP uses
the secure copy protocol for file transfers and displays the SCP Version option.
Selecting TFTP will use the insecure trivial file transfer protocol. The SCP login and
password should be entered in the Telnet username and password fields.
Table 43 describes the
Table 44
Dell PowerConnect W-AirWave | Version 7.3
describes