Using The Settings In The Visualrf > Setup Page - Dell PowerConnect W-Airwave User Manual

Using the Settings in the VisualRF > Setup Page
The VisualRF > Setup page, illustrated in
reconfigure these settings very carefully because these settings can impact your server's performance as well as
your location accuracy.
NOTE: Selecting Save will cause VisualRF to restart, disrupting or delaying the usability for up to 5 minutes.
Figure 202 The VisualRF > Setup Page
To enable VisualRF and tune memory and performance, navigate to the Server Settings section on this page. The
settings in this section are detailed in
Table 145 Server Settings Section of the VisualRF > Setup Page
Setting
Enable VisualRF Engine
Enable Multi-floor
Bleed-Through
Dynamic Attenuation
Dell PowerConnect W-AirWave | User Guide
Figure
Table 145:
Default Description
No Enables or disables the VisualRF engine. This setting must be enabled to use VisualRF.
If you do not have a license for VisualRF, this page will not appear.
Yes Enables or disables calculating the impact APs on floors above and below the currently
viewed floor in the Quick View.
Yes Incorporate AP to AP readings as well as site survey information and dynamically
recalculate the path loss of each radio to every grid cell on the floor plan, increasing
coverage and location accuracy.
202, configures advanced settings for VisualRF. Please
Using VisualRF | 265