Using The Rogue Containment Audit Report; Using The User Session Report - Dell PowerConnect W-Airwave User Manual

and group, and all are sorted according to rank. Selecting a value under the Device column in any table will take
you to the APs/Devices > Monitor > Radio Statistics page for the band indicated in the table title (5 GHz or 2.4
GHz).
Every list contains Rank, Device (name, not type), Channel Changes, Average Noise, Average Channel

Utilization, Users, Bandwidth, Location, Controller name, Folder, and Group.
The third column in the list (after Device) will be the column the list is sorted by.

If that column would otherwise be in the list (Channel Changes), it does not show up in the list where it

would otherwise.
Note that sometimes the sorted column is not one of those common ones, such as the Interfering Devices

section.
AMP limits data storage to 183 days (approximately six months) per radio. If you create an RF Health Report
with a date range longer than 183 days, it will only include Channel Changes, Transmit Power Changes, Average
Utilization, Mac/Phy Errors and Average Noise based on whatever part of the report intersects the last 183 days.
This differs from most reports because other data (like bandwidth and users) maxes out at 425 days, and AMP
validates reports so you can only run them over a 366-day duration.

Using the Rogue Containment Audit Report

The rogue containment audit report that lets you know if any containment is failing.
fields and information in this report type.
Figure 182 Reports > Detail > Rogue Containment Audit Report Page Illustration

Using the User Session Report

The User Session Report extensively itemizes user-level activity by session- any instance in which a user connects
to the network. In list and chart form, this report tracks and display session information that can include any or all
of the following:
Session Data by OS (List or Chart)

Session Data by OS Detail (List or Chart)

Session Data by Model (List or Chart)

Session Data by Manufacturer (List or Chart)

Session Data by Device Type (List or Chart)

Session Data by AOS Device Type (List or Chart)

Session Data by Network Interface Vendor (List or Chart)

Session Data by Network Chipset (List or Chart)

Session Data by Network Driver (List or Chart)

Session Data by EAP Supplicant (List or Chart)

Session Data by Asset Group (List or Chart)

Session Data by Asset Category (List or Chart)

Dell PowerConnect W-AirWave | User Guide
Figure 182 illustrates the
Creating, Running, and Emailing Reports | 247