Dell PowerConnect W-Airwave User Manual page 137

Table 82 APs/Devices > Manage, Additional Settings (Continued)
Setting
Subnet Mask
Gateway
5. Locate the Template Options area on the APs/Devices > Manage page.
NOTE: This section only appears for IOS APs, Symbol and Dell PowerConnect W controllers in groups with Dell PowerConnect W
UI Config disabled.
Table 83
Table 83 APs/Devices > Manage > Template Options Fields and Default Values
Setting
WDS Role
SSL Certificate
Extra Device
Commands
switch_command
6. For Cisco WLC devices, go to the interfaces section of the APs/Devices > Manage page. Select Add new
Interface to add another controller interface, or select the pencil icon to edit an existing controller interface.
Table 84
by AMP, refer to the Cisco WLC product documentation.
Table 84 APs/Devices > Manage > Interface Fields and Descriptions for Cisco WLC Devices
Field
Name
VLAN ID
Port
IP Address
Subnet Mask
Gateway
Dell PowerConnect W-AirWave | User Guide
Default Device Type
None All
None All
describes field settings, default values, and additional information for this page.
Default Device Type
Client Cisco IOS
Wireless LAN
Controllers only
None Cisco IOS
None Cisco IOS
None Cisco Catalyst
switches
describes the settings and default values. For detailed descriptions of Cisco WLC devices supported
Default Description
None The name of the interface on the controller.
None The VLAN ID for the interface on the controller.
None The port on the controller to access the interface.
None The IP address of the controller.
None The subnet mask for the controller.
None The controller's gateway.
Description
Provides the IP subnet mask to identify the sub-network so the IP
address can be recognized on the LAN. If DHCP is enabled, the
current assigned address will appear grayed out and the field cannot
be updated in this area.
The IP address of the default internet gateway. If DHCP is enabled,
the current assigned address will appear grayed out and the field
cannot be updated in this area.
Description
Set the WDS role for this AP. Select Master for the WDS master APs and
Client for the WDS Client. Once this is done you can use the %if
wds_role= % to push the client, master, or backup lines to appropriate
WDS APs.
AMP will read the SSL Certificate off of the AP when it comes UP in AMP.
The information in this field will defines what will be used in place of
%certificate%.
Defines the lines that will replace the %ap_include_1% variable in the
IOS template. This field allows for unique commands to be run on
individual APs. If you have any settings that are unique per AP like a
MOTD you can set them here.
Defines lines included for each of the members in the stack. This field
appears only on the master's Manage page. The information in this field
will determine what is used in place of the %switch_command%
variable.
Discovering, Adding, and Managing Devices | 137