Configuring Acs Servers - Dell PowerConnect W-Airwave User Manual

Table 34 AMP Setup > WLSE Fields and Default Values (Continued)
Setting
Port
Username
Password
Poll for AP Discovery; Poll for
Rogue Discovery
Last Contacted
Polling Period
2. After you have completed all fields, select Save. AMP is now configured to gather rogue information from
WLSE rogue scans. As a result of this configuration, any rogues found by WLSE appear on the RAPIDS >
List page.
What Next?
Go to additional tabs in the AMP Setup section to continue additional setup configurations.

Complete the required configurations in this chapter before proceeding.


Configuring ACS Servers

This is an optional configuration. The AMP Setup > ACS page allows AMP to poll one or more Cisco ACS
servers for wireless username information. When you specify an ACS server, AMP gathers information about your
wireless users. Refer to
server to manage your AMP users.
Perform these steps to configure ACS servers:
1. Go to the AMP Setup > ACS page. This page displays current ACS setup, as illustrated in
Figure 32 AMP Setup > ACS Page Illustration
62 | Configuring AMP
Default Description
1741 Defines the port AMP uses to communicate with the WLSE server.
None Defines the username AMP uses to communicate with the WLSE server. The
username and password must be configured the same way on the WLSE server
and on AMP.
The user needs permission to display faults to discover rogues and inventory
API (XML API) to discover manageable APs. As derived from a Cisco limitation,
only credentials with alphanumeric characters (that have only letters and
numbers, not other symbols) allow AMP to pull the necessary XML APIs.
None Defines the password AMP uses to communicate with the WLSE server. The
username and password must be configured the same way on the WLSE server
and on AMP.
As derived from a Cisco limitation, only credentials with alphanumeric
characters (that have only letters and numbers, not other symbols) allow AMP
to pull the necessary XML APIs.
Yes Sets the method by which AMP uses WLSE to poll for discovery of new APs
and/or new rogue devices on the network.
None Displays the last time AMP was able to contact the WLSE server.
10 minutes Determines how frequently AMP polls WLSE to gather rogue scanning data.
"Configuring ACS for WDS Authentication" on page 61 if you want to use your ACS
Figure
Dell PowerConnect W-AirWave | Version 7.3
32.