Configuring Basic Group Settings - Dell PowerConnect W-Airwave User Manual

NOTE: When you first configure AMP, there is only one default group labeled Access Points. If you have no other groups
configured, refer to

Configuring Basic Group Settings

The first default device group that AMP sets up is the Access Points group, but you can use this procedure to add
and configure any device group. Perform these steps to configure basic group settings, then continue to additional
procedures to define additional settings as required.
1. Go to the Groups > List page. Existing device groups appear on this page.
2. To create a new group, select Add. Enter a group name and select Add. The Groups > Basic page appears.
To edit an existing device group, select the manage (wrench) icon next to the group. The Groups > Basic
page appears. If you mouse over an existing group's wrench, a popup menu allows you to select Basic,
Templates, Security, SSIDs, AAA Servers, Radio, Dell PowerConnect W Config or Cisco WLC Config to
edit those pages as desired, as illustrated in
Figure 39 Pop-up When Hovering over Wrench Icon in Groups > List
72 | Configuring and Using Device Groups in AMP
"Configuring Basic Group Settings" on page 72.
Figure 39.
Dell PowerConnect W-AirWave | Version 7.3