Paper Size Not Detected - Canon imagePROGRAF iPF815 User Manual

The roll width set in Fit Roll Paper Width in the
printer driver does not match the width of the roll loa-
ded in the printer.

Paper size not detected.

Paper has been loaded askew, or warped paper has been loaded.
iPF815
Cause
Cause
Error Message
Corrective Action
Hold down the Stop button for a second or more to cancel
printing.
Make sure the roll width selected in the dialog box displayed
when you select Fit Roll Paper Width in the printer driver
matches the width of the roll loaded in the printer, and then
try printing again.
Corrective Action
Follow these steps to reload the roll.
1. Lift the Release Lever.
2. Open the Top Cover.
3. Adjust the right edge of the roll to make it
parallel to the right Paper Alignment Line.
4. Lower the Release Lever.
5. Close the Top Cover.
6. If "Not finished printing. Finish printing
remaining jobs?" is shown on the Display
Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
(See "Loading Rolls in the Printer.")
If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push the
roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the printer.
(See "Attaching the Roll Holder to Rolls.")
→P.623
Follow these step to reload a sheet.
1. Lift the Release Lever.
2. Open the Top Cover.
3. Adjust the right edge of the sheet to make it
parallel to the right Paper Alignment Line and
the trailing edge of the sheet to make it paral-
lel to the paper alignment line under the Paper
Retainer.
4. Lower the Release Lever.
5. Close the Top Cover.
6. If "Not finished printing. Finish printing
remaining jobs?" is shown on the Display
Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
> Messages regarding paper >
→P.628
Paper size not detected.
13
895