Hp-Gl/2 Jobs Are Printed 6 Mm Larger Than Specified; Hp-Gl/2 Jobs Are Printed At Maximum Size, Even If A Standard Size Is Specified; Hp-Gl/2 Printing Takes A Long Time; The Printer Stops When Printing A Hp-Gl/2 Job (The Carriage Stops Moving) - Canon imagePROGRAF iPF815 User Manual

HP-GL/2 jobs are printed 6 mm larger than specified

The page size of the HP-GL/2 print job, as created in the source ap-
plication, is incorrect.

HP-GL/2 jobs are printed at maximum size, even if a standard size is specified

Cause
The page size of the HP-GL/2 print job, as cre-
ated in the source application, is incorrect.

HP-GL/2 printing takes a long time.

Large print jobs with a lot of data take longer to print.

The printer stops when printing a HP-GL/2 job (the carriage stops moving)

Cause
The printer is analyzing the
print job.
iPF815
Cause
In MAIN MENU, set PageSizeProcess2 or Conserve Paper to On.
The layout will be changed to the optimal layout.
(See "Main Menu Settings.")
Cause
Either wait a while for printing to resume, or on the printer Control Panel, set Input
Resolution to 300dpi.
(See "Main Menu Settings.")
Troubleshooting
Corrective Action
In MAIN MENU, set PageSizeProcess1 to On.
(See "Main Menu Settings.")
Corrective Action
→P.722
Corrective Action
On the printer Control Panel, set Input Resolution to 300dpi.
(See "Main Menu Settings.")
Corrective Action
→P.722
HP-GL/2 jobs are printed 6 mm larger than specified
> HP-GL/2 problems
→P.722
→P.722
>
12
883