3.2
Configuring the Printer
Use the control panel to activate the protocol to be used.
To use TCP/IP as the transport protocol, you need to set IP address, subnet mask, and
gateway address to the printer. Refer to "Chapter 2.2.1 Setting IP Address" for information on
setting each of these addresses.
3.2.1
Set the IP address
When using TCP/IP as the transport protocol, you must set an IP address, subnet
mask, and gateway address on the printer.
See the manual provided with the printer for procedures.
3.2.2
Activating the Protocol
The factory setting of each protocol is set as Enabled. The following procedure is not
necessary when you are setting up the network for the first time using a new printer.
To use TCP/IP as the transport protocol, activate Protocol as SMB TCP/IP , and to use
NetBEUI, activate as SMB NetBEUI. And to use both, activate both protocols.
The procedure is as follows:
3.2.3
Checking the Settings (Printing Printer
Settings)
Print the Printer Settings to check settings. The Printer Settings is printed out using the
control panel.
3
77