Table of Contents
Advertisement
6.3 Making CentreWare Internet Services Settings
Transport Protocol
Retrieve E-mail
Now
Permitted E-mail
Address 1/
Permitted E-mail
Address 2
Password for Only
Read Data
Password for Full
Access
6
Recipient E-mail
info Address
Notification Items
Status E-mail Info
Sending Interval
156
Setting
Displays the transport protocol used in Status Messenger. To
change the TCP/IP settings, click TCP/IP on the page. This
will send you to the TCP/IP Settings (Maintenance) Page.
Check whether the incoming mail server has received a new
email.
Example of setting
For "fujixerox.co.jp", only E-mail from ???????? fujixerox.co.jp
(???????? is an optional address) is received.
Allows the user to input Permitted E-mail Addresses
(addresses from which commands are accepted) consisting of
up to 31 alphanumeric characters. The user may specify up to
2 Permitted E-mail Addresses: Permitted E-mail Address 1,
and Permitted E-mail Address 2. If neither Permitted E-mail
Address 1 nor Permitted E-mail Address 2 are specified,
commands are accepted from all users.
When setting a Read Only password, select Enable Password
and input a password of up to 7 alphanumeric characters. This
password is used when the user sends email to the device to
check information. Be sure to set this password if you selected
Enable Password. Access is not possible unless a password is
set.
Deselecting Enable Password clears the password.
When setting a Full Access password, select Enable Password
and input a password of up to 7 alphanumeric characters. This
password is used when the user sends email to the device to
check information or change settings. Be sure to set this
password if you selected Enable Password. Access is not
possible unless a password is set. Deselecting Enable
Password clears the password.
Allows the user to input the Email Address to notify the status
changes up to 63 bytes of alphanumeric characters. An email
will be sent to this address when the occurance of the Status
Type selected at Notification Items is found in the Device.
Allows the user to configure Status Type. The check box of
Status Type to notify by email is selected.
Allows the user to set the polling interval to check the Device
Status. The interval range is from 1 to 255 minute(s). The
email to notify the status will be sent when the occurance of
the Status Type selected at Notification Items is found in the
Device.
Description
Advertisement
Table of Contents
