Table of Contents
Advertisement
Setting IP Address at the Control Panel
After using the control panel to specify Setup IP Address as Panel, specify other
settings like the IP address, subnet mask and gateway address.
The IP address is controlled by the whole network system. If a wrong IP address is set, the
whole network might be affected. Confirm the IP address assigned to you with the network
administrator.
For details about how to make the settings, refer to the printer's user's guide.
2.2.2
Activating the Protocol
The factory setting of each protocol is set as Enabled. The following procedure is not
necessary when you are setting up the network for the first time using a new printer.
To print in TCP/IP environment, set all the protocols to be used from the following:
LPD
G
Port 9100 (available with Windows 95/98/Me/2000/XP)
G
IPP (available with Windows Me/2000/XP)
G
To start the SNMP agent feature in TCP/IP environment, set SNMP UDP/IP for
Protocol.
For details about how to start the protocol, refer to the printer's user's guide.
2.2.3
Checking the Settings (Printing Printer
Settings)
Print the list below to check the printer's configuration.
The contents of the printer settings list differ according to the printer model and the options
installed. For details about how to print the printer settings list, refer to the printer's user's
guide.
2.2 Configuring the Printer
2
15
Advertisement
Table of Contents
