7.2
For SMB Environment
7.2.1
When Setting Up the Printer
Condition
Cannot access the
printer from the
Windows client
due to forgotten
administrator
name and
password.
Cannot overwrite
Is there an error message
the config.txt file.
written in the config.txt file?
Did you try to overwrite the
file at the printer after using
and editing the copied
config.txt file on the client?
Verification
-
The factory settings of both the administrator
name and password are admin.
If you are using CentreWare Internet
Services‚ reset the administrator name and
password.
If the connection still cannot be made,
navigate to 5:Network at the control panel,
and choose YES for Ready to Init. However,
in this case, all network settings will be
returned to factory settings. Before you
proceed to choose YES for Ready to Init, it is
recommended that you print out the Printer
Settings to check the present settings first.
If the config.txt file is changed and saved, a
message.txt file will be created in the
admintool folder. If an error message is
written in this file, changes will not be
effective. Check the setting contents of the
config.txt file and resave.
Delete the config.txt file inside the admintool
folder at the printer, and then copy it.
-
Switch off the printer, and then switch it on
again.
Solution
7
165