Panasonic KX-T336 System Reference Manual page 70

2.00 System Administration from
a Remote Location
Description
From a remote location, you can execute system
programming, diagnosis and traffic measurements
using a Dumb terminal.
For details about communication parameters,
refer to Section 9-D-7.00 "Communication
Interface."
Conditions
0 RMT card (Modem) must be installed in the
system and register the telephone number of
modem in the System-Operation "Remote
Directory Number" (FDN: 3 or 4 digits) for
accessing the remote administration feature.
For further information about "Remote Directory
Number," refer to Section 1 O-C-4.00 'Operation
(OPR)."
., For remote access, a data terminal and modem
are required at a remote location.
l
Factory programmed 4 types of password from
1 st to 4th level for remote operation are
provided. Passwords are originally factory
programmed, but may be changed at any time.
Refer to Section 8-F-l -00 "Change Level (CHL).
n
l
You can execute remote system administration
during on-line communication mode only. But
when you load the system programming data
from a remote location, the system shifts to off-
line communication mode automatically.
Refer to Section 17-B-2.02 "Loading Procedure"
for details.
0 Starting up system administration from a remote
location can be done only in Dumb mode.
Operation
Starting up system administration from a remote
location can be done in the following ways:
Dial "Remote Directory Number" using Direct
Inward System Access (DISA) feature.
For further information about DISA feature,
refer to 3-D-2.02 "Direct Inward System Access
(DISA)."
Program DID feature so that the incoming
telephone number is converted to the "Remote
Directory Number."
For further information about DID feature, refer
to Section 3-D-2.03 "Direct Inward Dialing."
Assign that a call from a remote-location can
access the Remote Administration feature"
automatically using DIL (1 :l) feature.
For further information about DIL (1:l) feature,
refer to Section 3-D-2.01 "Direct In tine (DIL)."
Remote access by operator transfer
The call from a remote location can be made
on any trunk into the system, and be answered
by the operator.
The call is then placed on hold and the Remote
Directory Number of the system dialed is
received. The operator transfers the call after
receiving the modem answer tone. The caller
at a remote location will then hear the modem
answer tone and can proceed with sign-on.
Refer to Section 4-F-l -05 "Unscreened Call
Transfer to Remote" for further information.
When the system administrator at a remote
location accesses the system remote
administration feature, the following message
appears on the display of operator's telephone if
display is provided.
1234:RMT Access
After you log in to the system from a remote
location, you can operate the system in the same
way as if you were on-site.
Only one system administration terminal can
access the system at a time.
8-A-2