Panasonic KX-T336 System Reference Manual page 104

Continuec
Assigning Items
Selection of Value
I
Reference
Basic Shelf BS (02) Automatic set Blank : Not assigned
1 -A-5.OG
OHCA : T-SW Off-Hook Call Announcement 1-E-1.0O
card
to 2.00
1 -E-7.00
Expansion Shelf 1 FS (01 to 15) Automatic set Same as Basic Shelf FS
Expansion Shelf 2 FS (01 to 15) Automatic set Same as Basic Shelf FS
to 21 .oo
Description of Assigning Items
Basic Shelf FS (01 to 12)
Defines the type of card installed in the free slots (01 to 12) of the
basic shelf.
Basic Shelf BS (02)
Used to utilize the T-SW OHCA card or not
Expansion Shelf 1 FS (01 to 15)
Defines the type of card installed in the free slots (01 to 15) of the
expansion shelf 1.
Expansion Shelf 2 FS (01 to 15) Defines the type of card installed in the free slots (01 to 15) of the
expansion shelf 2.
Conditions
. The cursor does not move to BSOl and BS03.
In BS02, assignable value is OHCA or Blank.
If no CO trunk card (LCOT, GCOT, DID) is assigned, Trunk-CO Line" screen
cannot be selected.
If no Extension card (PLC, SLC, HLC, OPX) is assigned, 'Extension-Station" screen
cannot be selected.
.,
If AGC card is not assigned, "Trunk-AGC' screen cannot be selected.
If DPH card is not assigned, 'Extension-Doorphone" screen cannot be selected.
If ATLC card is not assigned, "Extension-Attendant Console" screen cannot be
selected.
If DISA card is not assigned, "Spa&al Attended-DISA" screen cannot be selected.
If DID card is not assigned, Special Attended-DID" screen cannot be selected.
When assigning a card, the oard status is Out of Service (OUS). When utilizing the
card, the card status should be set to In Service (INS).
For In Service (INS) and Out of Service (OUS), refer to Section 7-J-4.00 'INS (In
Service)" and Section 7-J-5.00 "OUS (Out of Service)."
For confirming whether the card status is INS or OUS, refer to Section 14-G-3.02
"Card Status screen."
When deleting (selecting blank) or changing the preassigned card type, the condi-
tions should be the followings:
l
The card status is OUS or Fault.
l
All of the port data has been deleted.
9-c-4