Panasonic KX-T336 System Reference Manual page 602

Programming
Item
Zescmton
Assignable
Parameters
Default
How to
input
Trunk
Shelf
Assign LCO' or GCOT car3 No. to the
Blank
system which ar,e dwadabm !or power
1,2,3 or blank
D
No. 1
failure transfer.
-18
Slot
01-15 or blank
Blank
D
Extension Shelf
Slot
Assign HLC or SLC card No. to the
Blank
system which are available for power
1,2,3 or blank
D
failure transfer.
01-l 5 or blank
Blank
D
D: Enter appropriate parameters directly.
S: Select appropriate parameters from the factory-set options.
l
Cursor is scrolled from left to right by pressing the return key.
l
Assign extension card and trunk card for power failure transfer in pairs.
To assign only a trunk or an extension is not possible.
Refer to Section 9-L-2.00 "Power Failure Transfer Assignment" for further
information about programming.
Conditions
SLT telephones and some PITS telephones can
be used during power failure if power failure
transfer assignment had been done in advance.
The following PITS telephones can be used
during power failure.
KX-T123230, KX-T123230D,
KX-T123235, KX-T61630, KX-T30830
When you are using above listed PITS tele-
phones, set the POWER FAILURE switch to ON,
when power failure occurs.
If dialing cannot be done, set the DIALING MODE
selector to another position (PULSE or TONE).
When the power is restored, set the POWER
FAILURE switch to OFF.
If the power is restored during a conversation, set
the POWER FAILURE switch to OFF after
conversation is completed.
14-H-2