Panasonic KX-T336 System Reference Manual page 292

Continued
tern
bmtzer
Assigning Items
- .___
Input Value
09 : DPH (Doorphone Circuit) card
10 : AGC (Automatic Gain Control) card
11 : DISA (Direct Inward System Access) card
12 : RMT (Remote Circuit) card
13 : TSW-OHCA (Off-Hook Call Announcement) card
Conditions
If "SLA" command is entered without index number, all physical slot numbers (except 113 and
115) will be displayed in ascending order (from 101 to 315).
It is impossible to select Index No.1 13 and 115, because Index No.1 13 is fixed to CPU card and
115 is fixed to T-SW card.
If Index No.1 14 is selected, assignable input value is limited to "00: none" or "13: OHCA."
:
If no CO trunk card (LCOT, GCOT, DID) is assigned, it is not possible to program
."CO Line (COL)."
If AGC card is not assigned, "Automatic Gain Control (AGC)" cannot be
programmed.
If DPH card is not assigned, "Doorphone (DPH)" cannot be programmed.
If ATLC card is not assigned, it is not possible to program "Attendant Console
(ATT)" and "Attendant Queue Priority (AQP)."
If DISA card is not assigned, it is not possible to program "DISA (DIS)", "DISA
Code (DIC)" and "DISA Password (DIP)."
If DID card is not assigned, ft is not possible to program "DID (DID)."
When assigning a card, the card status is Out of Service (OUS). When using the
card, the card status should be set to In Service (INS).
For In Service (INS) and Out of Sevice (OUS), refer to Section 8-F-3.00 "In
Service (INS)" and Section 8-F-4.00 "Out of Service (OUS)."
For confirming whether card status is INS or OUS, refer to Section 15-F-1.02 "Card
Status Screen."
When deleting or changing the pre-assigned card type, the conditions should be
the followings:
l
The card status is OUS or Fault.
l
All of the port data has been deleted.
However, if there exist port data, it is possible to change the cards as follows:
l
PLC card- HLC card
l
SLC card v HLC card
1 o-c-3