Panasonic KX-T336 System Reference Manual page 410

1.00 Entering PITS System Programming Mode
Procedures for seting PITS system programming mode :
Operation
1. Set the MEMORY switch at
the rear of PITS to "PRO-
GRAM."
2. Dial U* #." (program number
3. Dial the PITS Programming
Password: four digits.
. . .
Result
l
The message below appears
on the display:
1 PITS-PGM No? + 1
l
The MEMORY button
indicator lights in red.
l
The PITS programming pass-
word entry screen appears on
the display:
ENTER PASSWORD ]
l
The MEMORY button
indicator light goes out.
l
The message below appears
on the display:
1 SYS-PGM No?
I
l
The MEMORY button
indicator lights in red.
-- s:---
When nothing is entered within one minute after "Initial
display for PITS system programming mode" is dis-
played, "Initial display for PITS station programming
mode" is displayed again.
Comment/Note
l
This display is called "Initial
display for PITS station
programming mode."
. If the programming data of your
PITS is already accessed by
another system administration
device, the following message
appears on the display.
Already Accessed
l
This display is called "Initial
display for PITS system pro-
gramming mode."
l
The password characters are
not displayed when they are
entered for security reason.
. Entry of an incorrect password
causes an alarm tone.
l
If the following message
-+. appears, the system is already I.
accessed by another admini-
stration device:
Already Accessed
You can return to the operation mode whenever you
slide the MEMORY switch to SET.
11 -c-2