Panasonic KX-T336 System Reference Manual page 580

4.03 Port Test procedure
Enter the test command according to the following
format.
(Refer to Section 14-F-4.01 "Functions to be
Tested.")
(a) When testing the port status on the following
cards. (PLC, HLC, ATLC, DISA, AGC)
I Port No. (l-8, or * )
Card No. (01-15 or **)
Shelf No. ( 1: Basic 2: Expansion 1
3: Expansion 2)
(Note) y *" or '**" means "All"
=> 2***...All ports in the Expansion Shelf 1
=> 105* . . ..All ports assigned to the card No.05
in the Basic Shelf
(Example)
Executing port 211
l
test
(b) When testing extension (SLC, HLC, OPX) port I
and CO trunk port (LCOT, GCOT) in pairs
=>Extension port No. & CO trunk port No.
WwvW
=> 1011&2011
=> DN4000&2012
_--. .
:
(c) To verify the status of the speech path of the
specified conference trunk, enter the conference
trunk No. as follows.
Before testing, change the status of target con-
ference trunk to Qut of Service" by entering
OUS command.
Refer to Section 14-G-3.04 'Conference Trunk
Status screen."
(2)
=> C F 0
Optional conference trunk
No. (01-84)
(Example)
=>CFOOl
(Note) Conference trunk test can be done at the
port test screen and the test result is
displayed just under the entered
command as follows.
=>CFBOl
*****Pass
(1) => C F B I_t
I Basic conference trunk No.
(01-08)
14-F-9