Panasonic KX-T336 System Reference Manual page 609

Jministration
ministration
the System
;ystem programming and
em using a dumb
unication parameters,
3 "Communication
xess to the
#es of the system is
rd.
,ized person from learning
mord characters are not
'e entered.
;ystem administration
)rd (4-digit. Alphanumeric
antered.
le system, password must
stored in memory.
3 passwords are provided
31 for on-site operation and
!ration from a remote
Drrect password, the
kmb initial Screen from
7to programming mode or
l
Alphanumeric characters
ASCII codes except special codes (DEL, ESC
etc.)
But entering "/" "- n are not available, because
these characters cannot be displayed on the
display of PITS.
Both uppercase and lowercase characters
can be recognized by the system. *
1.02 Dumb Operation Mode
When you log in to the system administration
terminal, "Select the Mode" screen appears on
the display.
At initial prompt in this screen, you can enter into
programming mode by entering PRG, and
operation mode by entering OPE.
In programming mode, assigning and changing
the system programming parameters can be
done. In operation mode, monitoring, testing and
maintaining the system can be done.
Refer to Section 8 'Preparation for Programming
and Maintenance (Dumb Type Ten-tinal)" for
further details about Dumb operation mode.
entering the
n the Error Log
I the Error Log
I the Error Log
'or log records
he
following two
M&or Alarm)
0
rror Log Screen."
ltomatic
3 functions available to each
to all levels
;em level parameters
: level parameters
3rameters only.
le system using the 1 st level
!xecute all functions, but are
Id when entering level 2,3
knted out.
SIO #2 port on the
le, then set
r Log to UY."
ration (OPR) for
Tally factory programmed,
I when logging in to the
:he 1st level password.
:-1 .OO 'Change Level (CHL)"
3rd level.
15-B-l