Panasonic KX-T336 System Reference Manual page 643

3.03 Loading Procedure
Load - Submenu
1 OFL 1 BCK 1 LIN j DIR
________-__________-------------------------------
--_------ + .---. + ---- + ---- +.---
1. ALL Data
2. PBX Data
3. ATT1 Local Data
4. ATT2 Local Data
[Submenu Description] 1. First, confirm that the preparations for start of
communication between sender and receiver
have been made, like uniform communication
parameters for sender and receiver etc.
2. Select '1. Load" from the Backup Utility Main
Menu, then Load-Submenu Screen appears on
the screen. (See above)
3. Select the area (1 to 4) with the submenu.
(Refer to [Submenu Description].)
4. The loading start message "Transfer start"
appears on the screen, and the system waits
for the data from the backup device.
5. Change the backup device to Data Send mode.
Saved data is transmitted as ASCII codes from
the backup device to the system.
6. When loading of the saved data is finished, the
following message appears on the screen.
"Transfer end"
7. Release the Data Send mode of the backup
device.
8. You can edit the just loaded data in off-line
mode.
And if you want to restart the system (enters to
on-line mode), set the Operation Switch
(MODE) to on-line mode, and press the RESET
button.
For further information about Operation Switch,
refer to Section 2-F-2.00 "CPU Rotary-Switch
Features."
1. All Data Loads all data, system
programming data and attendant console
database (ATT1 and/or AlT2), from backup
device to Main Unit.
2. PBX Data . ..Loads PBX data (system
programming data) from backup
device to Main Unit.
3. ATT1 Local Data . ..Loads the database of
attendant console
assigned as ATT1 from
backup device to Main
Unit.
4. ATT2 Local Data . ..Loads the database of
attendant console
assigned as ATT2 from
backup device to Main
Unit.
(Note)
Loading the saved data is possible during off-
line mode only. If you select "1. Load" in on-
line mode, an error message appears on the
screen and your selection becomes invalid.
No other troubles occur.
16-B-6