Mitsubishi Electric FR-A500 Instruction Manual page 172

<Setting procedure>
(Example: Set point No. 1, forward rotation, 30Hz, 4 hours 30 minutes)
1) Read Pr. 201 value.
2) Enter "1" (forward rotation) in Pr. 201 and press the
parameter unit).
3) Enter 30 (30Hz) and press the
4) Enter "4.30" and press the
5) Press the key to move to the next parameter (Pr. 202), and press the
the FR-PU04 parameter unit) to display the current setting. Hereafter, press the
parameter one by one.
Note: 1. To make a stop, write "0" in the rotation direction and frequency. Set "9999" for no setting.
2. An error will result if 4.80 is entered (59 minutes or 59 s is exceeded).
• Assuming that operation has been programmed as indicated in the following table, the operation pattern is
as shown in the figure below:
No. Operation
1 Forward rotation, 20Hz, 1 hours 0 minute
2 Stop, 3 hours 0 minutes
3 Reverse rotation, 30Hz, 4 hours 0 minutes
4 Forward rotation, 10Hz, 6 hours 0 minutes
5 Forward rotation, 35Hz, 7 hours 30 minutes
6 Stop, 9 hours 0 minute
<Operation pattern>
(4) Input signals
Name
Group signal
RH (group 1)
RM (group 2)
RL (group 3)
Timer reset signal (STR)
Programmed operation start
signal (STF)
(5) Output signals
Name
Time-out signal (SU)
Group select signals
(FU, OL, IPF)
key ( key when using the FR-PU04 parameter unit). (Note 1)
SET
WRITE
key ( key when using the FR-PU04 parameter unit). (Note 2)
SET
WRITE
2 3
Set point 1
Forward
20Hz
rotation
4
0 1 3
Description
Used to select the group for programmed
operation.
Input to zero the reference time of day.
Input to start programmed operation.
Description
Output on completion of the operation of
the selected group and cleared on timer
reset.
Output during running of corresponding
group's program and cleared on timer
reset.
key ( key when using the FR-PU04
SET
WRITE
Parameter Setting
Pr. 201 = 1, 20, 1:00
Pr. 202 = 0, 0, 3:00
Pr. 203 = 2, 30, 4:00
Pr. 204 = 1, 10, 6:00
Pr. 205 = 1, 35, 7:30
Pr. 206 = 0, 0, 9:00
4 5 6
35Hz
10Hz
6 7:30 9
Time of day
Signal Level
Photocoupler isolated
Signal Level
Open collector output
(isolated)
163
PARAMETERS
key ( key when using
SET
READ
key to advance the
Remarks
May also be driven by
transistor.
When ic = 10mA, Vec<0.5V
should be satisfied.
Remarks
Permissible load
24VDC, 0.1A
Only when Pr. 76 = 3
4