Operating Sequences - Siemens Sinumerik 810T User Manual

09.91
DRY RUN YES-NO
With "YES", the axes are traversed at the dry run feedrate, not the programmed feedrate. The
dry run feedrate is set via setting data.
EDIT
EDIT leads to "SELECT PROGRAM", "GUIDING" and "SIMULATION".
Editing means:
– Input of a program into the memory or changing or altering a program already in the
memory.
ENABLE
You can enable the handwheel for the selected axis with this softkey.
ETX START
Output of the end of block character (end of text)
FEED
You select the G functions for the type of feed via softkey. Preselect: softkey "GUIDING".
G FUNCT.
You select the G functions from groups G 0 to G 12 via softkeys (see Programming Guide).
Preselect: "GUIDING" softkey.
GUIDING
The operator guiding (operator prompting) function speeds up and simplifies the input of part
programs.
Apart from geometric functions (G function, contour definition) you can also input machining
cycles and technological functions (feedrate, spindle speed) via softkeys.
HANDWHEEL
In the INC 1...INC 10000 operating mode you activate an electronic handwheel via softkeys.
The electronic handwheel enables operation which is equivalent to jog handwheel operation.
HW VERSION
You can display the hardware data by operating this softkey.
Preselect: DIAGNOSIS and SW VERSION softkeys.
INPUT DISPLAY
To call up the input displays with corresponding operator guidance macros configured by the
machine tool manufacturer from the user memory submodule. Please refer to the information
supplied by the machine tool manufacturer for the actual menus, display descriptions and

operating sequences.

LINE
You select the G functions for linear interpolation by means of a softkey.
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810T, GA3 (BN)
6ZB5 410-0EP02
2 Operation
2.5 Glossary of softkey functions
2-67