Selecting A Program - Siemens Sinumerik 810T User Manual

3 Operating Sequences
3.1.13 Program management

3.1.13.9 "Selecting a program"

Using "SELECT PROGRAM", you can either start a new program, or call a program already
stored in the program memory, e.g. for editing (3.1.12) or simulation (3.1.14) .
Sequence of operation
PART
PROGRAM
EDIT
5
% J
SELECT
PROGRAM
The program number called is shown on the CRT and, if there is a program with this
number already in the memory, the start of the program and blocks N0005 to N ... .
3-66
Operate the "PART PROGRAM" softkey in any of the
operating modes:
PRESET / JOG / AUTOMATIC /
INC FEED 1 .... INC FEED 10 000 / REFPOINT.
Operate the "EDIT" softkey.
Using the keyboard, enter the desired program number
"%..." (or "L...") "% 5" in this example.
Operate the "SELECT PROGRAM" softkey.
Using the "Page up/down" keys, you can
call up the parts of the program not yet displayed (if
already in memory) onto the CRT.
© Siemens AG 1990 All Rights Reserved
11.90
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)