Table of Contents
Advertisement
3 Operating Sequences
3.2.3 Influencing "AUTOMATIC" operation
((Foto - Nr. 810T/47 einmontieren))
3
or
%
L
...
...
• • •
...
...
• • •
START
The axis positions programmed in the current block are
After "BLOCK SEARCH", you can traverse the difference between the actual position and
the calculated command position, by selecting the axis and using the jog keys, in "REPOS"
operating mode.
Block search in the L95/96 cycles: if comment texts are in the contour
program without block numbers, the control outputs the alarm 3000
3-102
This screen form appears with the
input field marked in inverse video.
Input "%" for the main program or "L" for the
subroutine and then press the input key. The
inverse marking jumps to the next field for the
program number.
Using the numerical keyboard enter the pro-
gram number " ... ", and store it with the input
key.
Using the numerical keyboard enter the block
number " ... " for the search destination, and
store it with the input key.
Operate the "START" softkey.
approached with linear interpolation.
Caution: danger of collision!!
Using the "Program start" key, activate
program processing.
"General programming error".
© Siemens AG 1990 All Rights Reserved
01.93
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)
Hide quick links:
Advertisement
Table of Contents
