Simulation; Simulation "Area Of The Workpiece - Siemens Sinumerik 810T User Manual

3 Operating Sequences

3.1.14 "SIMULATION"

3.1.14 "SIMULATION"
With the "SIMULATION" function, it is possible to test a program. The traversing movements
of the tools are simulated graphically on the CRT.

3.1.14.1 Simulation "AREA OF THE WORKPIECE"

• A graphic display with input fields simplifies the input of the values for the simulation area
and the dimensions of the workpiece.
• Select the simulation area so that the programmed traversing range is covered.
• The values entered need not be in proportion to the display; the simulation area is not cut
off, because the control evaluates the larger value for the display.
The NC channels and the simulation channel can influence
each other because they use common data.
Common data are, for example:
– Settable zero offsets
– Programmable zero offsets
– Tool offset
– Global R parameters
– Machine data
– Setting data.
Any influencing of the data in the NC channels by the simulation channel,
can be prevented using an interlock. Simulation simultaneously with
Sequence of operation
PART
PROGRAM EDIT
3-72
processing then is not possible.
In any of the operating modes
PRESET / JOG / AUTOMATIC /
INC FEED 1 .... INC FEED 10 000 / REFPOINT, operate the
"PART PROGRAM" and "EDIT" softkeys one after the other.
© Siemens AG 1990 All Rights Reserved
11.90
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)