Correction Display ("Correction Block") - Siemens Sinumerik 810T User Manual

11.90

3.1.12.1 Correction display ("CORRECTION BLOCK")

When processing or simulating (see Section 3.1.14) a program, the program processing is
stopped and the relevant alarm displayed when the control recognizes a programming error.
Using the "CORRECTION BLOCK" function the block or the word to be corrected will be
marked.
Sequence of operation
CORR.
PART
BLOCK
PROGRAM
The cursor is now positioned in front of the block/word recognized as containing an error.
...
7
X
• • •
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810T, GA3 (BN)
3.1.12 Program correction ("EDIT"): Insert/modify/delete word, insert/delete block
Operate the "PART PROGRAM" softkey, and then
subsequently the "CORRECTION BLOCK" softkey, in any of
the operating modes:
PRESET / JOG / AUTOMATIC /
INC 1 .... INC 10 000 / REFPOINT.
Using the keyboard, now correct the relevant address
(address "X" in the example) and enter the appropriate
value,
subsequently operate the "Modify word" key.
After the correction operate the "Program start" key to
continue program progressing.
6ZB5 410-0EP02
3 Operating Sequences
3-57