Siemens Sinumerik 810T User Manual page 148

11.90
((Bild 810T/11 einmontieren))
EDIT
1 2
F D
%
SELECT
PROGRAM
GUIDING
BLOCK
NUMBER
© Siemens AG 1990 All Rights Reserved
SINUMERIK 810T, GA3 (BN)
This display appears on the CRT.
The control shows you the last part
program called, in the example
program no. "%88".
Operate the "EDIT" softkey.
Enter the desired program no. "%12".
Using the "SELECT PROGRAM" softkey call the desired
program.
Operate the "GUIDING" softkey.
Operate the "BLOCK NUMBER" softkey. The
block number "N0005" is displayed.
Note:
The block numbers are generated by the control in steps
of 5, i.e. after each LF (end of block) the block number is
incremented by "5".
6ZB5 410-0EP02
3 Operating Sequences
3.1.10 Program input
3-47