Setting Data Bits - Siemens Sinumerik 810T User Manual

3 Operating Sequences
3.1.15 Data input/data output

3.1.15.1 Setting data bits

The setting data - from byte No. 5000 to 5029 - each consist of 8 bits: No. 0 to No. 7.
These setting data serve for the matching of Interfaces 1 and 2, for the connection of different
devices.
Explanation of setting data - structure:
(e.g. for setting data ( SD ) 5011)
5011
1 1 0 0 0 1 0 0
7 6 5 4 3 2 1 0
Setting data no.
Using an input form on the CRT you can enter the desired bit pattern for any byte in the
range 5000 to 5029.
Sequence of operation
SETTING
DATA
SETTING
BITS
3-78
Bit pattern of the byte of
setting data 5011
Operate the "SETTING DATA" softkey in any of the operating
modes.
Using the ETC key, extend the displayed softkey menu.
Using the softkey, select the "SETTING BITS" function.
© Siemens AG 1990 All Rights Reserved
possible bit statuses:
"0"= Bit is not set
"1"= Bit is set
Bit no.
6ZB5 410-0EP02
SINUMERIK 810T, GA3 (BN)
09.91